First use - could not find automatic frame restart

Sequence Generator
1

First time using SGP. Ran my sequence - it tried to plate solve which I had not yet setup so that failed. I turned that off and tried to restart. But I kept getting “Automatic frame restart is active, but you have specified a value of 0 as the guiding error threshold (this means any error whatsoever will restart the current frame).”

I could not find this setting. Where do I fix this?

2

Go to Control Panel/Auto Guide Tab/Restart current frame. You need to set that value above 0.

Control Panel Auto Guide Restart Current Frame

3

Found it, thank you.

I had completely turned off the guiding interface so I assumed all the settings on this tab would therefore be disabled.

I doesn’t make any sense to me that if set to “No Auto Guider”, that “restart current frame when” should terminate my sequence.