Invisible Control Panel window

Sequence Generator
1

I use a NUC next to the scope to run SGP and remote into it via RDP from my laptop. A couple of nights ago I started up SGP and couldn’t open the Control Panel. Luckily I was repeating a sequence I’d already set up the previous night and could get the info I needed from the docking modules. I l realized later what had happened - during the day I had connected the NUC directly to a 1600x1200 monitor, run SGP and moved the Control Panel down to the lower right. Later when running from the laptop’s 1300x768 screen via RDP, the Control Panel was off screen and invisible. I couldn’t work out how to reset its position or move it back on to the physical screen. So the next day I attached the NUC direct to the big monitor again and moved Control Panel back up to the top left.

This was on v3.0.3.140

Is there a way to reset the position of the Control Panel window, or are there e.g. keycodes to move it around?

2

Try View / Docking Modules / Reset Module Layout

3

I did try that but the Control Panel is not a docking module.

4

Use Win+R to bring up the run command and run this:
"c:\Program Files (x86)\Sequence Generator\Sequence Generator.exe" /reset

Then relaunch SGP. That should reset the CP and Sequencer.

Thanks,
Jared