Light Frame Found Before Park Command

As I finally got ready to start imaging I was getting this error message and sequencing would not start. Not being able to figure out what it was talking about I finally deleted all the sequences and started from scratch. And before deleting, I had checked the first sequence and there was no park command anywhere in it.

What was that error message about?

Farzad

If you save and post your sequence we can take a look. There is likely a park command some where on one of the events and light frames after it.

Thanks,
Jared

I don’t think I have the copy saved after I deleted the sequences. What is
interesting is that I was using an older sequence and I was out gathering
more of the same data. And the sequence had worked fine before.

Farzad