Sequence Generator Pro (RC4) is Released for Testing

Sequence Generator Pro (RC4) is released for testing.

SGPro 2.4 (Beta 10 or higher) will require PHD2 2.4.1e or better to function properly: You can download it here:

Release Candidate 4 Changes:

  • Fixed bug where slews would fail if the telescope was selected from a profile
  • Possibly fixed a bug with “mis-marked” bad images

Release Candidate 3 Changes:

  • Fixed an issue where weather station connect and settings buttons were disabled when the weather station was selected as part of an equipment profile.
  • Possible fix for dialogs appearing behind their parents

Release Candidate 2 Changes:

  • Fixed a bug that would prompt a sequence to start guiding even if no active light frames were detected
  • Fixed an issue where, if the user did not disable the “Auto-Off” feature for Canon cameras (via the camera), SGPro would let it turn off.
  • Added a new recovery type to detect and fix failure to flip calibration data (prevents recalibration of auto guider after meridian flip failure)
  • Possible fix to wait for flatbox to open/close prior to imaging.

Release Candidate 1 Changes:

  • Serious Issue: Fixed an error where opening an image in SGPro might cause the image to become corrupted permanently (due to duplicate header entries)
  • Fixed a bug where closing child windows might displace the main SGPro window
  • Fixed a bug where sequence end times might be in the past (despite the fact that they should be in the future)
  • Added an option where auto focus dark frames only need to be with +/- 2sec of the exposure length to be applied
  • Added ability to apply CR2/CRW/NEF darks to auto focus frames (same rules apply to naming these images)
  • Removed duplicate XPIXSZ and YPIXSZ FITS header entries
  • Disabling image history navigation during image download
  • Fixed a bug that could alter the behavior of “Focus on sequence start” in an unpleasant manner
  • The auto guider will now always attempt to “settle” prior to taking a light frame (even if the dithering option is not selected).
  • The manual rotator direction can now be reversed if your profile has a gear combination that causes the image to be “flipped”

As always, you can find it here:

This topic is now a banner topic. It will appear at the top of every page until it is dismissed by the user.

This topic is not a banner topic anymore. It will no longer appear at the top of every page.