The title says it all. If I am given an option to continue the sequence or not because the initial plate solve was too far off, and I choose to continue the sequence, SGP hangs. I am on SGP 3.1.0.254.
Please look at the last few lines of this log: Dropbox - File Deleted
I had to kill SGP after waiting a few minutes since it had hung.
Do you recall what SGPro looked like when it was unresponsive? Was the centering status window still up?
Yes, it first tried plate solving with PlateSolve2, which failed after it reached the end of its search. Then it tried doing a blind solve, which is when the message stating that the solve might be bad was shown… I checked the option to continue the sequence anyway. At this point the centering window was still displayed on screen with zero results at the bottom of the window (where it shows the plate solve accuracy and how many pixels it is off by). It hung in this state (main window visible, and centering action window also visible with no results). This is very easy to reproduce on my system… it happens every time the solve is too far off center.