There are lot of things to do on SkyFlats taken by AutoFlats.
Bugs/feature requests:
- Autoflats scheduler when showing before and after previews (via right-down corner), it not correctly updates the screen (time of start and end when it should run) or updates it only after a few seconds
- Autoflats scheduler should not run in times when it was not scheduled to run. It should behave like it is not enabled and not ask every time during the night if it should run. This of course only in case if the light source is Sky.
- Autoflats sequence should behave like regular sequence target. In case if light source is Sky, it should open the dome->sync the mount with dome, connect equipment and begin to take flats
- In case of SkyFlats, in case of minimum exposure time detected in the evening or maximum eposure time detected in the morning it should not abort the flats sequence, but it should wait for 60 sec. and try again, because the sky will be dimmer/brighter in a while.
- The autoflats sort order “Narrowband toward light” is great, but it would be better if default order will be “Ha, SII, OIII, R, G, B, L” in the evening and reverse order at morning. Today it is not reversed and is changed to this “R, G, B, L, Ha, SII, OIII”. This is wrong order, because the exposure times are not in “right” order to be ± equal to each filter in the changing sky light conditions.