Auto centre after auto focus?

Sequence Generator Auto Focus
1

I am using a 9.25 EdgeHD using a Boss-II feather touch auto focus. As autofocus in this case is moving the mirror then there is inevitably some mirror shift, even with focus backlash set so that mirror is always moving up at end of focus. Consequently the image needs to be re-centred after auto focus. Can I and if I can how, do I set SGP to carry out an auto-centre following an auto-focus.

There was a thread on this in 2019/20 but it didn’t seem to lead to a resolution of the issue.

2

This comes up every once in a while. There is currently no way to do this explicitly, but it shouldn’t be too difficult to add (the new control panel makes it much easier to do)

3

Ken, thank you for the reply. It would be hugely helpful if this was possible.