Close dome and park scope when failure

Would it be possible to automatically close the dome en park the telescope when the sequence abort/fails?

Whether the sequence finishes OR fails it parks the mount and closes the dome for me. I have RECOVERY set to on…but if it does not recover…then it parks the scope & closes (and parks) the dome.

have you these setting checked?

Only have “Mount Park Closes Shutter” checked.Will check the other options too.
Do I also have to check “Park when sequence completes”? So the checkbox " Park when sequence completes" will also park when the sequence fails?

It does for me. Once the sequence finishes - for whatever reason - then SGP parks mount & dome.

Thanks! I’ll give it a try…