I’m not sure how easy or if this could be implemented but, I (and I’m sure others do as well) use a side by side setup with an RC6 and 94mm refractor. I swap the imaging camera and guide cameras depending on what I am going to image with. When i do swap the cameras, the focus steps are much different and it takes a while to get a reasonable focus in order to begin the auto focus routine. Is there a way to have a “default” or “base line” focus point associated with the profile that is being used? Something that could be just clicked on to move the electronic focuser to that position or even just an information box, like in the equipment profile manager, that would allow entering the steps for reference?
Thank you,
Harvey.