Horizon Plate Solving

Hello folks,some nights a go i had an object low on the horizon and the mount wont slew,warning message says that i have set limit of 18 degrees,how can i change that?

Highly likely that is set in ASCOM EQASCOM rather than SGP, I had this once.

Look for the ‘Spanner icon’ in ‘Mount Limits’ section - Take a look in there first to confirm.

ASCOM will override SGP full stop if it see’s fit leaving SGP wondering what the hell to do next


Hi Paul, the box where says “enable limits” is uncheked.

Hi Davide,

check also the value for the Site Horizon in the User Profile Manager.

Kind Regards,

Yessss, thx that what set at 20 degrees👍