Meridian Flip issue icw Paramount ME

We have at our remote site in Spain a Bisque Paramount ME i.c.w. TheSky6 and an ASCOM driver currently using SGP 2.6.0.24. When we try to do an automatic Meridian flip it does not execute it (Minutes Past Meridian set to 0 and Wait for meridian switched on). The software does not postpone creating subs and/or executing the desired flip when the meridian is finally reached.

The logging states:
[08-16-18 16:34:02.218][DEBUG] [Sequence Thread] Checking if Meridian Flip is needed
[08-16-18 16:34:02.218][DEBUG] [Sequence Thread] Meridian flip not needed, telescope on Unknown side

We were taking 5 minutes subs and the meridian was due at 16:35 during this test run.

The telescope driver does not provide the needed telescope side information. Is there still a way to automatise the flip and if so, how would we realize this?

Rob, I have an MX and I have fully automated meridian flips without any difficulty with SGP over all versions. There are a number of TSX settings, however, that can mess things up. PM me and we can compare settings.