Plate solve does not sync the scope!

Sequence Generator SGPro Support
1

Performing a plate solve and the solver found my location immediately; however it will not sync the scope.

Link to Logs

Approx time of issue: 7:30 PM

Useful Info

OS: Microsoft Windows 10 Enterprise LTSC
Ver: 4.2.0.1158 (32-bit)
.NET: 4.8
ASCOM: 6.6.1.3673

2

Hi there,

I have a Gemini mount, and I need to tell it to sync the mount in the driver dialogue. Possibly yours too?

Clear Skies!

Paul

3

The attached logs to not cover the specified timeframe, but, in addition to the gemini setting @promero noted, SGPro also has a setting that directs the plate solver to sync (or not). It is set to sync by default, but it has been changed accidentally before. In the Control Panel on the Telescope tab, check the field labeled “Sync Behavior” and make sure it is NOT set to a type that reads offset.