Rasa8 with motoried and arduino control roll off roof observatory.
I have searched the forums and other places for an answer and I am baffled. My roll off roof has worked flawlessly for years with SGP. Recently it has started powering off the equipment before the roof closes. I have the Disconnect all equipment at sequence end checked in the Sequence panel. If I uncheck this the shutdown process closes the roof but does not disconnect the equipment. If I check the box the shutdown process disconnects the equipment and leaves the roof open.
The observatory settings are:
Slave to scope on sequence start
Mount unpark opens roof
Open roof first, then unpark mount
Mount park closes roof
Park mount first, then close roof.
I have toggled all these settings off and on as well as Slave to telescope but nothing has resolved it yet. It seems to have started when the control panel was integrated with all the options in one place but this is a guess.
If I unpark the scope (roof opens) and then tell SGP to run end of sequence operations, it parks, closes roof, and disconnects equipment (assuming the disconnect check box is checked).
SGPro 4.2.0.1052
Thanks,
Stan