Runtime error 76 path not found

Hi everyone, New to the forum. I have been using platesolve2 with no issues for about a month, but last night ran into a repeated runtime error 76 “path not found” that resulted in a failed solve each time. The asttometry.net failover worked, but is obviously much slower to solve than platesolve2. My settings haven’t changed at all, so I’m a little confused as to where to start troubleshooting.

I am using an Atlas eqg, hyperstar, zwo asi 2600 and C11.

Thanks in advance!

It may be helpful to post some logs so we can see what is going on:

Also might want to double check your PlateSolve2 settings and just make sure that the directories are setup correctly.

Jared