Sequence Generator Pro 4.2.0.933 (32-bit and 64-bit) is Released for
Hello! Thanks for keeping SGPro up to date. This release on the stable branch is free of charge to owners of SGPro 4. The list below contains a brief description of all feature additions, changes and fixes in this version.
You can find it here:
https://www.sequencegeneratorpro.com/downloads/
Sequence Generator 4.2.0.933
Additions
- Added more logging information SMTP email message failures.
Changes
- For mount drivers that do not protect against it, SGPro will now condition both right ascension (values greater than 24) and azimuth (values greater than 360) before sending slew commands.
- When SGPro fails to save an image to disk, the notification will be much more specific about the nature of the error.
Fixes
- Addressing rotator docking module and handling for sky vs mechanical angles.
- Fixed a condition in which SGPro might crash or fail initialize the Equipment Profile Manager when querying certain types of ASCOM switches.
- Fixed a condition that might cause the older native QSI driver to cause a crash.
- Fixed an issue where a failure to reach the MSS licensing server might reset the SGPro license to the Lite version.
- Fixed an issue where drag to reorder targets might corrupt that targets events in certain circumstances (remote desktop especially)
- Fixed an issue where several potential errors during the optional pre-flip wait period would not propagate that issue to the notification system.
- Fixed an issue where SGPro might crash during evaluation of an image for Image History.
- Fixed an issue where the camera may not disconnect at end of sequence if the camera had already been warmed up from a previous unsafe event.
- Fixed an issue where the new Sequence Information tooltip icon would not be visible when the sequencer was in its Expanded Mode.
- Selecting Mechanical angle for rotator now zeros mechanical angle rather than sky angle.