SGP continues to solve after centering

Sequence Generator
1

HI All,

This is my second request on this topic and I feel like I am close to resolution. Here is the current problem.

When plate solving , SGP slews to target, images and begins to solve. The target is in the center of the screen, but GSP continues to solve. Eventually, the program aborts and will not intergrate even though the target is clearly centered.

I have changed the accepted error to 500 pixels.

Any suggestions would be greatly appreciated.,

Thanks, Bill

2

Bill - there is always at least one solve on the downloaded image - for stars, it is easy to tell if the image is centered but for deep sky objects, the center is not always as obvious. When the solver works, can you see the error report (briefly) at the bottom? That might give some clues. The other possibility is that you have a rotator and it has not moved?

3

Buzz,

Thanks so much for your response !

One answer is easy, there is no rotator and i have all the rotator blocks unchecked.
The error that I get is failed to center.

Thanks, Bill

4

Bill - are you using the framing and mosaic wizard to set your target - that sometimes locks you into a rotation too, which then causes later issues.