Hello. I’m tryin to jump back into SGP after a two year hiatus and did a fresh install of everything. Here is what I’m running:
Windows 11
SGP 4.1.0.832 32bit
ASCOM 6.5.10
Paramount MYT
I was able to connect my 6D and run through autofocus, but when I go to start the sequence I get an “error connecting to Canon EOS” and all the equipment buttons turn red. I’m pretty sure that is what the error said, but I didn’t check the log files until this morning. I’ve included what I think is the relevant log at the bottom. I’m sure there is a way to attach a file, but I couldn’t find it. I’m probably missing something very basic here so thanks in advance!
I am pretty certain that wasn’t the correct log (I removed it for readability). That log did not run a sequence. If you can locate the correct log, please send it an we’ll take a look.