SGPro 4.5.0.1450 Public Alpha Available for Test

[Ken]

@STAstro

Can you change it so that if all the switch ports are already at the desired state that it doesn’t throw up an error saying it was unable to set the switch port states.

Sorry, I’m not sure what this means. What is a switch port? If you are referring to switch state values, SGPro should never complain if a switch is already in the state it’s supposed to be in.

@MSiniscalchi

Regarding the autoguider not pausing during a recentering, that still is there with this updated version.

Oh. Ok, I had somehow misinterpreted this (original) report. Too many moving parts I guess. Thx for the details here. I’ll take a look…

@STAstro

Now it correctly saves the End time, however it says “Today”

It depends for how long SGPro has been open. Currently there is no dynamic refresh for this field, but I can add it. In other words, If SGPro was opened before 9pm, then it is correct that it reads “today”. But in reality, it is only important that the internals of SGPro understand it to be “today”. From user’s perspective, I think it safe to always show the “next” end time as long as it isn’t propagated to the sequencing engine (which would cause your sequence to continually end)

@MStringfield

When the telescope mount is connected, the docking telescope module “Park/Unpark” and “Set Park” buttons do not seem to function for me.

Thx, will investigate

@MStringfield

When clicking any of the equipment docking modules option button (down triangle in top right of the module next to the “x”) and select the relevant settings link (e.g. Telescope Settings), it opens the control panel to the correct settings page in the right panel but the selection in the left panel seems to show the last manually selected option.

Yep, thanks. Lot’s of spots like this need to be converted to use the new open the Control Panel method… still using the old method that pre-dated the tabs on the left side.