SGPro stop sequence when roof closes

Is it possible to have SGPro stop a sequence and park the mount when the roof closes?
I have the Observatory module set up and it shows when the roll-off roof is open and closed. I have sensors that will close the roof automatically if it starts raining and the wind is too high. In those cases, the Observatory module shows the roof is closed, but SGPro doesn’t abort the current sequence.

Is there a way to have SGPro abort the current sequence and park the mount when it detects the roof was closed? The documentation mentions having SGPro close the roof for various conditions, but not the other way around.

Hi Eric,

I asked a similar question not too long ago and two solutions were offered in the form of Safety Monitors that can read roof status files. See this post:

https://forum.sequencegeneratorpro.com/t/skip-camera-warm-up-on-unsafe-conditions/16482/2

Best,

Luca