Strange Sequencing Behavior

After spending a good 30 minutes figuring out the required exposures for flats, I had a sequence setup for LRGBHSO. However, upon initiation of the sequence, it would appear as if SGP would do one or two in one Event then jump into another Event without having completed one or the other event. Very strange. Right now I have other events unchecked so the events go one by one.

I haven’t seen this behavior. We would need logs and the sequence file to investigate.

Thank you ,

I found out later that there is an option to finish an entire event or loop through the various events. That option defaulted to looping through all events.